801S Vibration Sensor Module 6mm Coupler 8 4 9 100 RPM

8 4 9 100 RPM 150 80 0

Cable Length: 30cm/12"

and bam - any future I2C packets will get sent to that port

Although it uses a single-wire to send data it is not Dallas One Wire compatible

you can but they must be at least 50 k-the internal ones to AVRs / for Arduino are about 100 k ohms

801S Vibration Sensor Module 6mm Coupler 8 4 9 100 RPMThis Vibration sensor is based on the high precision vibration sensor 801S, it has 2 outputs, includes TTL and analog output, the sensitivity of TTL output can be adjusted by the on board potentiometer, you can also read the analog output with any ADC to get the vibration condition. Size: 20mm X 32mm X 11mm Operating Voltage: 5V Sensitivity can be adjusted using Potentiometer The main chip: LM393, 801S With the signal output instructions With analog